Simons Voss Technologies Palm LDB Version 1.40 Instructions d'exploitation télécharger pdf (Page 59)

Manual – LDB 1.5

Page 59

Elevator main building

→

Name of the lock of the SmartRelay belonging to the Output

Module

Mod#0

→

Address of the SmartOutput Module

Out#5

→

Address of the output of the SmartOutput Module

Sig#1

→

Signaling mode active, the output shows the status of output 1

by flashing

SmartOutput Module – Inverting outputs

Since the outputs of the SmartOutput Module are not available as changeover

contacts from a hardware point of view, the software offers you the possibility to

configure the inversion of the Module’s outputs. By checking or un-checking the Invert

outputs box, the output can be defined as a NC or a NO contact.

The relay outputs of the SmartOutput Module are always NC contacts in terms

of their hardware.

Inverting the outputs always applies to the entire Output Module.

Increasing the number of SmartOutput Modules

If you need to add more SmartOutput Modules to your Lock System, then these

should also be assigned to the corresponding SmartRelay type lock.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 157 158

Pas de commentaire

Simons Voss Technologies Palm LDB Version 1.40 Instructions d'exploitation Page 59