Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation télécharger pdf (Page 132)

LON – Network 3065

Page 20

7.0 Repeater

7.1 Method of Operation

The repeater increases the allowable communication distance by regenerating the

signals. Unlike routers, the repeater does not have a group ID, so it does not have to

be configured by SimonsVoss.

7.2 Assembly Instructions

Install it in a small housing that is suitable for DIN rail assembly. Connect the (LON)

network lines to terminal screws on both sides. The power supply – which can be

either AC or DC – is on one side of the housing. Feed the cable screen through to the

opposite side.

The repeater always needs a separate power supply, which is not included in the

delivery!!!

Repeaters, as they come from the factory, do not have any over voltage protection.

For this reason, this protection should be already provided for by the customer.

8.0 Terminators

To avoid disturbances, you must use a so-called terminator (pull-

up resistor) in the bus system as the segment termination.

Connect this pull-up resistor to terminals 1 and 2 of the last

LockNode and also to the network equipotential bonding.

1 2 ... 127 128 129 130 131 132 133 134 135 136 137 ... 218 219

Pas de commentaire

Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation Page 132