Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation télécharger pdf (Page 203)

VdS Shunt lock function 3066

Page 28

5.0 Special Versions of the Shunt lock function 3066

5.1 Operating the Activation Unit without a Deactivation Unit

If you want to activate and deactivate the burglar alarm system externally with the

transponder instead of with a key, you only need a master activation unit (MA). In this

case, however, you will lose the true purpose of the Shunt lock function.

 You need to connect only pins 1 and 2 for the power supply, the floating switch

contact (pins 5, 6, 7) and the sabotage contacts (pins 8 to 11). Do not connect

the other lines of the activation unit (refer to Chapter 2.3).

5.2 Operating the Deactivation Unit without an Activation Unit

If you continue to operate the alarm system with a standard key, you can do without

the activation unit.

Connection assignment

Connect the supply voltage (separate power supply) to soldering terminals 1 and 2.

Connect terminals 13 and 15 over a relay contact of the alarm system (floating make

contact). If there is a lock switch contact, wire this to soldering terminals 12 and 15

(Refer to Chapter 2.2).

☺ As long as soldering terminals 13 and 15 are connected to one another, for

example, by a relay point of the alarm system, all digital locking cylinders

equipped with a deactivation unit are deactivated. This means it is not

possible to accidentally go through these doors when the alarm system is

activated.

1 2 ... 198 199 200 201 202 203 204 205 206 207 208 ... 218 219

Pas de commentaire

Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation Page 203