Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation télécharger pdf (Page 209)

VdS Shunt lock function 3066

Page 22

3.2 Programming the Deactivation Units (DA)

Click the line in the locking plan above the one where you want to add a deactivation

unit. Select

New  Locking. Then give the deactivation unit a name:

 Such as Deactivation unit, main entrance

In the field

Type, select Control unit. Click OK & Exit. If you want to set up additional

deactivation units, repeat these steps.

☺ If you always add the deactivation units above the accompanying digital

locking cylinder, you will have a better overview of the system.

Deactivation units do not need any authorizations which means that you do not have

to insert any crosses. Approve your locking system and program the deactivation

units under

Programming  Locking.

 The deactivation unit needs supply voltage during the programming. You can

provide this with a 9-volt compound battery, for example. Program activation

unit(s) and deactivation units separately from one another. Do not wire the two

components until after you have programmed them successfully.

1 2 ... 204 205 206 207 208 209 210 211 212 213 214 ... 317 318

Pas de commentaire

Simons Voss Technologies Palm LDB Version 1.40 Manuel d'installation Page 209